Chevy Avalanche Tire Pressure (TPMS) Reset / Relearn Guide

Chevy Avalanche Tire Pressure (TPMS) Reset / Relearn Guide – The Chevrolet Avalanche is a four-door pickup to be used in sport utility shares the long wheelbase chassis used in the Chevrolet Suburban and Cadillac Escalade EXT. Unlike the typical truck, the open bed of the avalanche area opens to the seat back through a folding panel (marketed as a “central divider) and the rear window is removable. A series of three removable panels form a tight lid of the cargo box. Additional storage is provided behind each wheelwell, accessed by locking flip-top panels and can be used as self-draining ice chests.

After sales continue free fall, Chevrolet will stop production of variants of the double cabin pickup and crew cab Avalanche. Final version of the Chevy Avalanche will slide in 2013. The last series of Avalanche gliding in 2013 is Black Diamond. This model is equipped with a rear camera, parking feature, the automatic gas pedal, fog lights. There are two variants Avalanche Black diamond marketed by General Motors, the LS and LT series.

2004-2013 Chevrolet Avalanche Tire Pressure (TPMS) Reset / Relearn Guide:

To turning off or reset the Tire Pressure Monitoring System (TPMS) light on your 2004, 2005, 2006, 2007 Chevy Avalanche, follow these steps:

  • Stop the vehicle in a safe place and turn the ignition switch to RUN with the engine off and engage the parking brake.
  • Turn headlight switch from OFF to parking lamps 4 times within three seconds. A double horn chirp will sound and the SERVICE TIRE MONITOR message will be displayed on the Driver Information Center (DIC) to indicate the learn mode is enabled.
  • Increase/ decrease tire pressure for 10 seconds, starting from the driver’s side front tire (LF) until horn sounds.
  • After horn sounds, proceed to the right (passenger’s side) front tire, and repeat the procedure in step 3.
  • Next, proceed as in step 3 for the right (passenger’s side) rear tire and then left (driver’s side) rear tire.
  • After hearing the confirming horn chirp for the left rear tire, turn ignition to OFF position. Adjust all tires to pressure listed on tire placard.

For more details, please watch the following video:

For the new model (2008 2009 2010 2011 2012 2013) you must have a TPMS relearn tool to reset the Tire Pressure Monitoring System (TPMS) sensor  and follow these steps:

  • Turn the ignition to position On without starting the engine.
  • Press the DIC MENU button on the turn signal lever
  • Scroll up and select “Tire Pressure Menu” by use the thumbwheel
  • Press the SET/CLR button
  • When a message requesting acceptance of the process appear, press the SET/CLR button again
    to confirm.
  • The horn sounds twice to signal the receiver is in relearn mode
  • Starting from the driver’s side front tire, place the relearn tool against the tire sidewall, near the valve stem. Then press the button to activate the TPMS sensor.
  • Repeat the procedure on the right-front tire, the right rear tire, and the last one left rear tire.
  • A horn chirp confirms that the sensor identification code has been matched to this tire and wheel position.
  • Turn the ignition off and start the engine to verify the indicator has been reset.

For more details, please watch the following video:

This procedure should be work on all generation of Chevy Avalanche (2004, 2005, 2006, 2007, 2008, 2009, 2010, 2011, 2012, 2013) models. Hopefully the article of Chevy Avalanche Tire Pressure (TPMS) Reset / Relearn Guide usefull for you. Good Luck!

(Visited 5,807 times, 12 visits today)
Posted in Tips Tagged with: , ,

Leave a Reply

Your email address will not be published. Required fields are marked *

*