Buick Verano Low Tire Pressure TPMS Sensor Light Reset Guide

Buick Verano Low Tire Pressure TPMS Sensor Light Reset Guide – The Verano is a compact car produced by Buick since 2011. He made his debut at the Motor Show in Detroit on January 10, 2011. It was the first compact model sold by Buick in the US by the end of production of the Skylark. The Verano is part of a trio of nearly identical models produced by General Motors. The other two are the Buick Excelle GT, developed and manufactured in China for the Asian market quoted, and the Opel Astra unveiled at the Moscow Motor Show 2012. These three sedans share the Delta II platform of General Motors with the Chevrolet Cruze sedan and the Chevrolet Orlando MPV and Opel / Vauxhall Zafira.

“Verano” in Spanish means “summer”. Jim Federico, chief engineer of the Verano, has led the development, while David Lyon, responsible for the design of Buick cars, he designed the car body. The monocoque of Verano consists of fenders, hood, roof and galvanized steel door panels, while the bumpers are the thermoplastic polyolefin. In addition, the Verano is equipped with laminated glass that allows a good acoustic insulation, triple seals of the doors, an abundant use of sound-absorbing material and alloy rims.

Buick Verano Low Tire Pressure TPMS Sensor Light Reset Guide:

If you receive a low-tire pressure monitoring system (TPMS) warning light while driving and you want to clear or turning off the warning light on your 2012 2013 2014 2015 2016 Buick Verano, follow these instructions:

  • Make sure the vehicle is at a complete stop
  • Turn the engine switch off
  • Adjust the tire inflation pressure recommended on the tire placard located on the door panel.
  • Driving for a few miles (kilometers), calibration will complete after 2 minutes of cumulative driving at 20 mph (32 km/h).

If you replaced a wheel, tire, TPMS sensor etc. and are now getting a warning light on your car, then the sensor needs to be reset. To relearn or reset the Tire Pressure Monitoring System (TPMS) sensor on your 2012, 2013, 2014, 2015 2016 2017 Buick Verano you must have a TPMS relearn tool and follow these steps:

  • Stop the vehicle in a safe place and turn the engine switch off and engage the parking brake.
  • Turn the ignition to position On without starting the engine.
  • Press the DIC MENU button

  • Scroll up and select “Tire Pressure Menu”
  • Press the SET/CLR button
  • When a message requesting acceptance of the process appear, press the SET/CLR button again to confirm.
  • The horn sounds twice to signal the receiver is in relearn mode
  • Starting from the driver’s side front tire, place the relearn tool against the tire sidewall, near the valve stem. Then press the button to activate the TPMS sensor.
  • Repeat the procedure on the right-front tire, the right rear tire, and the last one left rear tire.
  • A horn chirp confirms that the sensor identification code has been matched to this tire and wheel position.
  • After hearing the confirming horn chirp for the left rear tire, turn ignition to OFF position. Adjust all tires to pressure listed on tire placard.

This procedure should be work on all generation of Buick Verano (2012 2013 2014 2015 2016 2017) model years. Hopefully the article of Buick Verano Low Tire Pressure TPMS Sensor Light Reset Guide useful for you. Good Luck!

(Visited 35 times, 1 visits today)
Posted in Buick, Car Tagged with: , , ,

Leave a Reply

Your email address will not be published. Required fields are marked *

*