2002 Chevy Monte Carlo TPMS Low Tire Pressure Light Reset

Last Updated on February 17, 2020 by Christ

2002 Chevy Monte Carlo TPMS Low Tire Pressure Light Reset – Monte Carlo is a Chevrolet car from 1970 to 1988 and from 1995 to 2007. In 2000, to inspire the design of the new model series, Chevrolet did not name just General Motors Motorsport, but it was also based on Monte Carlo in the past. Among the typical features of the previous Monte Carlo that were applied to the new model series, there was the design of the wheel arches, the rear vertical lights and the rear bumper. Another return was that of the “Knight Coat of Arms”, that is, a coat of arms typical of Monte Carlo of the past years that made the last appearance in 1988, and which was applied to the new series.

From a NASCAR racing experience, a rather aerodynamic line emerged. This series of Monte Carlo was assembled only in Oshawa. The available outfits were three, LS, LT and SS. The latter, already marketed in the past, was first offered on an onboard traction vehicle. The offer was automatic. In 2006, Monte Carlo, along with the Impala sedan homolog, was the subject of an important restyling. The updated model was presented to the public at the 2005 Los Angeles car salon. LS, LT, LZ9, LTZ, and LS4 were available.

2002 Chevy Monte Carlo TPMS Low Tire Pressure Light Reset

2002 Chevy Monte Carlo TPMS Low Tire Pressure Light Reset:

Time needed: 7 minutes

If you replaced a wheel, tire, TPMS sensor, etc. and are now getting a warning light on your car, then the sensor needs to be reset. To relearn, turning off or reset the Tire Pressure Monitoring System (TPMS) light on your 2002 2003 2004 2005  Chevy Monte Carlo, follow these steps:

  1. Stop the vehicle in a safe place and turn the engine switch off and engage the parking brake.

  2. Adjust all tires to pressure listed on the tire placard.

  3. Turn the ignition to the ON position without starting the engine and turn the radio off.

  4. Press and hold the TUNE DISP button until SETTINGS is displayed

  5. Scroll up and select “TIRE MON” by using SEEK PSCAN up or down arrow button

  6. Press the 1 PREV or 2 NEXT buttons until RESET is displayed

  7. When a message requesting acceptance of the process appears, press the TUNE DISP button to confirm

  8. The horn will be heard to signal the receiver is in relearn mode

  9. Once the monitor has been reset, scroll until EXIT appears on the display.

  10. Press the TUNE DISP button to exit the menu

  11. Driving for a few miles (kilometers), calibration will complete after 2 minutes of cumulative driving at 20 mph (32 km/h).

  12. Turn the ignition off and start the engine to verify the indicator has been reset.

For more details, please watch the following video:

This tutorial is based on the Chevrolet owner’s manual. This procedure should be work on the old generation of Chevy Monte Carlo (2002 2003 2004 2005) model years. Hopefully, the article of 2002 Chevy Monte Carlo TPMS Low Tire Pressure Light Reset useful for you. Good Luck!

(Visited 380 times, 1 visits today)

Leave a Reply

Your email address will not be published. Required fields are marked *

*

This site uses Akismet to reduce spam. Learn how your comment data is processed.